← Back to all guides
Frame Sideboard — Assembly guide
Step 1
Insert the nut into the plastic housing. Press firmly to ensure it sits fully inside. Repeat for all.
Step 2
Insert the plastic housing with the nut inside, into the pill-shaped slot. Ensure it’s oriented as shown and no part is protruding. Repeat for all.
Step 3
Place the bottom shelf on a flat and soft surface with the two slots pointing upward.
Step 4
Fit the two legs into their corresponding slots with the pockets facing outward.
Step 5
Fit the two side pieces into their corresponding slots and pockets. Make sure they are fully inserted.
Step 6
Using a non-electric flat-head screwdriver, drive in the two screws to secure the side pieces to the legs. Stop when the head sits flush with the surface; avoid over-tightening.
Step 7
Set the sideboard upright. Lower the top onto the legs and guide the tabs into their pockets. Take your time.
Step 8
Using a non-electric flat-head screwdriver, drive in the remaining two screws to secure the top to the legs. Stop when the head sits flush with the surface; avoid over-tightening.
Step 9
Finished