← Back to all guides

Dot Pedestal — Assembly guide

Step 1

Insert the nut into the plastic housing. Press firmly to ensure it sits fully inside. Repeat for all.

Step 2

Insert the plastic housing with the nut inside, into the pill-shaped slot. Ensure it’s oriented as shown and no part is protruding. Repeat for all.

Step 3

Lay the top on a flat and soft surface with the pockets facing upward.

Step 4

Fit the first leg into the pockets without the drill holes going through the top.

Step 5

Fit the next leg into its corresponding pockets.

Step 6

Make sure all pieces sits tight and flush with minimal to no gaps. Flip the pedestal over so it stands on the floor.

Step 7

Drive in the screws using a non-electric flat-head screwdriver. Stop when the head is flush with the surface; avoid over-tightening.

Step 8

Finished