← Back to all guides

Block Storage Crate — Assembly guide

Step 1

Insert the nut into the plastic housing. Press firmly to ensure it sits fully inside. Repeat for all.

Step 2

Insert the plastic housing with the nut inside, into the pill-shaped slot. Ensure it’s oriented as shown and no part is protruding. Repeat for all.

Step 3

Lay the first base plank flat on a smooth, clean surface with the pockets facing upward.

Step 4

Position the second base plank over the tabs of the side panels. Press down firmly so the tabs fit flush into the matching pockets.

Step 5

Secure the base plank by driving 2 screws through the pre-drilled holes until flush.

Step 6

Flip the assembly to reveal the first base plank and its pre-drilled holes. Secure the base plank by driving 2 screws into the side panels.

Step 7

Finished